‘Left’ and ‘Right’ are used as if you are sitting in drivers seat.

1. Starting & Driving
   1. Turn on battery disconnect switch
      • Turn on battery disconnect switch
   2. Turn on ‘Control Power’
      • Switch will illuminate green. If it does not, make sure E-stop is not pushed in.
   3. Start Engine using ‘Engine Start’
      1. The switch is like a normal key. Off-On-(Crank).
      2. If it does not start, do this: turn off, wait 1 sec, turn on, wait 1 sec, then start.
      3. If at any time the E-Stop is used, it will trigger an alarm on engine controller, and you will hear it beeping. The ‘Engine Start’ switch must be cycled Off-On-Off to reset the alarm.
   4. Press the Green ‘Low Speed mode’ button.
      • It is near center of operator panel, with a yellow button above it and red one below it.
      • It will illuminate green once pressed, and only after engine is running.
      • You cannot drive or steer before doing this.

Click pictures for a full size image

1. Open both valves.
   1. 
2. Connect fill hose and power cord.
   1. 
   2. Identify the connection bleeder thumbscrew (Red Circle), and fill valve (Green Circle):