public:gnc:operation_manual
This is an old revision of the document!
Table of Contents
Sterilizer Operations
‘Left’ and ‘Right’ are used as if you are sitting in drivers seat.
- Starting & Driving
- Turn on battery disconnect switch
- Turn on battery disconnect switch
- Turn on ‘Control Power’
- Switch will illuminate green. If it does not, make sure E-stop is not pushed in.
- Start Engine using ‘Engine Start’
- The switch is like a normal key. Off-On-(Crank).
- If it does not start, do this: turn off, wait 1 sec, turn on, wait 1 sec, then start.
- If at any time the E-Stop is used, it will trigger an alarm on engine controller, and you will hear it beeping. The ‘Engine Start’ switch must be cycled Off-On-Off to reset the alarm.
- Press the Green ‘Low Speed mode’ button.
- It is near center of operator panel, with a yellow button above it and red one below it.
- It will illuminate green once pressed, and only after engine is running.
- You cannot drive or steer before doing this.
Nurse Tank Operations
public/gnc/operation_manual.1660781189.txt.gz · Last modified: 2022/08/17 20:06 by pfox